Seth on Simulink

Archive for September, 2008


Seth Popinchalk is an Application Engineer for The MathWorks. He writes here about Simulink and other MathWorks tools used in Model-Based Design.
  • Guy: @Mary - Typically when you design a controller for a SimMechanics plant, you measure position and velocity...
  • Mike Tocci: Hi Ben, What version are you using? I just tried this on the demo model sl_subsys_enab1 in 9a and got,...
  • Ben Brown: The following does not appear to find enabled subsystems! find_system(gcs, ‘FollowLink...
  • mary: i have a SimMechanics set of blocks, transferred using Simmechanics Link from solidworks. It worked fine till...
  • Mohamamd: Hi Suth, I try to simulate a load tap-changing transformer in simulink but its control part has to be...
  • Han Geerligs: Hello Guy, thanks for the clarificaton and link. However in the documentation I am missing the...
  • Guy: @Han, you probably already know, but I think it is good to share with everyone. To zoom in use the key...
  • Han Geerligs: Hi Seth, Once again I’d like to point out that my biggest accelerator is using mouse and keyboard...
  • XaL: Hi, thanks for the tips. As someone wrote in http://blogs.mathwor ks.com/seth/2009/03/ 13/new-%C2%A0rele...
  • Uba osy: Hi, in the introductory example for fuzzy logic toolbox it was noted that using non fuzzy means, you could...

These postings are the author's and don't necessarily represent the opinions of The MathWorks.