Guy on Simulink

Simulink & Model-Based Design

Arduino Engineering Kit

Have you heard of the Arduino Engineering Kit?

If you are interested in DIY projects and are looking for a fun way to apply some control and robotics principles to a real system, you probably want to read this post.

Introduction

If you have been following this blog for some time, you are probably aware that I like using MATLAB and Simulink for various projects at home. For an example, see my sous-vide cooking machine posts.

When I heard that Arduino is now offering an Arduino Engineering Kit and that we have support packages to program it with Simulink, I contacted the team that put it together and asked if I could borrow one to play with it a bit.

When you buy the kit on the Arduino Store, you receive a box full of mechanical and electronic parts, including a Arduino MKR1000:

The Arduino Kit

The kit includes instructions to build three possible projects: a motorcycle, a rover, or a drawing robot.

The 3 projects in the Arduino kit

I decided to go for the motorcycle. I thought the inertia wheel making it self-balancing would be an interesting control project.

Getting Started

Once you have the kit pieced together, you will need to install a few packages in MATLAB:

The easiest way to install those is through the Add-ons menu in the MATLAB toolstrip.

After installing those three packages, I went in the examples folder of the Arduino Engineering Kit Hardware Support package and tried the examples one by one, to be sure I was able to utilize all the sensors and actuators. For example, here is my test of the IMU, where I tilted the motorcycle by 90 degrees back and forth along all axes. This allowed me to conclude that the axis I want to control, the roll angle of the motorcycle, is the second element of the Euler angles output, the Y axis.

Testing the IMU

My Model

The Engineering Kit Project Files also contain a complete model that balances the motorcycle and allows you to control its speed and steering angle. However I thought it would be more fun to build mine from scratch. If you are interested, you can download the final version here.

Here is a picture of the top level of the final result.

Top final model

Let's look at each of the components. To begin, on the left I created a subsystem with all the sensors I needed and combined them in a Bus.

Top final model

Next I process each sensor to extract the relevant data in convenient engineering units.

Top final model

Now it is time for the Stateflow chart acting as the brain of my model. On the left, I check for three conditions: That the IMU is calibrated, that the motorcycle has not fallen, and that the flywheel does not reach maximum speed. When all those conditions are met, I can then click the Start button at the top level of the model. Once this is clicked, I have 4 seconds of calibration where I hold the motorcycle perfectly vertically for calibration before I start the balancing. If the motorcycle falls, I can hit the button again to reset the controller and try again.

Top final model

When the chart enables the balancing, it turns on an Enabled Subsystem that activates the controllers. For the balancing fly-wheel, the controller is a PID that takes as input the roll angle of the motorcycle and generates a voltage command to the fly-wheel. For the motorcycle speed, this is a simple proportional controller, which takes as input the speed of the motorcycle, integrates it and compares it with the wheel encoder.

Top final model

Note that this balancing controller is not perfect. The sensors on the fly-wheel motor do not allow direct measurement of the fly wheel velocity, making it difficult to control the fly-wheel motion perfectly. We are working on that!

Finally, the output of the controllers is sent to the output driver blocks.

Top final model

And it works!

Here is a video showing the motorcycle in action:

Visit the Arduino Engineering Kit YouTube channel to see more examples.

Now it's your turn

Let us know what you think of the Arduino Engineering Kit in the comments below.

|
  • print

댓글

댓글을 남기려면 링크 를 클릭하여 MathWorks 계정에 로그인하거나 계정을 새로 만드십시오.