## Steve on Image Processing with MATLABImage processing concepts, algorithms, and MATLAB

Note

Steve on Image Processing with MATLAB has been archived and will not be updated.

# All about pixel colors: Grayscale and binary images

In my previous postings on this topic, I've discussed the basic image display models in MATLAB - truecolor and indexed. The Image Processing Toolbox has conventions for two additional image display models: grayscale and binary.

### Grayscale image display

If you pass a single argument to the toolbox's two main image display functions (imtool and imshow), they'll interpret the input as a grayscale image. Here's an illustration using a simple sinusoid:
theta = linspace(0, 2*pi, 256);
I = repmat((-cos(2*theta) + 1)/2, [256 1]);
h = imshow(I);                % Save the handle for use below.
As far as MATLAB itself is concerned, this is a scaled indexed image being displayed in a figure with a grayscale colormap installed. Here are the key properties that have been set to control the image display:
get(h, 'CDataMapping')
ans =

scaled


The toolbox convention is that, for floating-point images, 0 is displayed as black and 1 is displayed as white.
get(gca, 'CLim')
ans =

0     1


map = get(gcf, 'Colormap');
map(1:5, :)                   % Display the first few colormap colors
ans =

0         0         0
0.0039    0.0039    0.0039
0.0078    0.0078    0.0078
0.0118    0.0118    0.0118
0.0157    0.0157    0.0157


imshow (and imtool) handle all these details for you.

### Controlling the grayscale display range

imshow and imtool allow you to override the conventional display range and specify your own black and white values. You do this by providing a second input argument, a two-element vector containing the black and white values. In the call to imshow below, 0.4 (and any lower value) gets displayed as black. The value 0.6 (and any higher value) gets displayed as white.
imshow(I, [0.4 0.6])

### Binary image display

The other Image Processing Toolbox image display model is the binary image. If you supply a single input argument that is logical, then imtool and imshow (as well as many other toolbox functions) interpret that input as a binary image.
bw = imread('text.png');
islogical(bw)
ans =

1


h = imshow(bw);

### Relevant toolbox documentation

The Image Processing Toolbox Users Guide has a section called "Image Types in the Toolbox." This section describes the image types binary, indexed, grayscale, and truecolor, and it explains important dynamic range conventions as well. This is essential information for you to know in order to use the toolbox effectively.

Published with MATLAB® 7.2

|

### 댓글

댓글을 남기려면 링크 를 클릭하여 MathWorks 계정에 로그인하거나 계정을 새로 만드십시오.