Stuart’s MATLAB Videos

Watch and Learn

MATLAB Basics: Using dbstop if error

When MATLAB throws an error, if you are in a function, you will end up at the base workspace and lose access to the variables as they were in the function when the error was thrown. This makes it difficult to understand why the error occurred. With the debugger, MATLAB can stop when the error is thrown, so the variables are still in scope. This makes debugging much easier.
 
|
  • print
  • send email

댓글

댓글을 남기려면 링크 를 클릭하여 MathWorks 계정에 로그인하거나 계정을 새로 만드십시오.