Guy on Simulink

Simulink & Model-Based Design

Posts 11 - 20 of 26

結果: Analysis

Surprising Results from Modeling Queues with SimEvents 16

Today I am very happy to welcome guest blogger Ramamurthy Mani who works in our development organization.
Introduction
Have you ever been in a supermarket checkout and wondered why you are in the… 続きを読む >>

Simuflate: A time-based simulation of the Patriots’ footballs 12

Today I want to share a discussion I had with a few fellow guest bloggers: Corey Lagunowich, Zack Peters, Matt Brauer and Seth Popinchalk. Deflate-gate Corey: Hey guys, did you hear about the... 続きを読む >>

A bit of philosophy on reuse versus building from scratch 2

This week, we are welcoming Michael Burke, from our consulting group. Reuse: Or how I learned to love the Bat Man Lego set… Like many an engineer of my generation I grew up with the basic Lego®... 続きを読む >>

Detecting Failures with Online Parameter Estimation 1

In R2014a, System Identification Toolbox has new online parameter estimation capabilities. Let’s see how this works using a simple example! The Problem Let's say we have a setup where a DC... 続きを読む >>

What can Simulink Code Inspector do for you? 4

Some time ago I was having a discussion with my colleague Sarah Dagen, from our Consulting Services, and she began explaining Simulink Code Inspector™ to me. I immediately stopped her and said:... 続きを読む >>

Optimizing the Hyperloop Trajectory 2

We previously published two-dimensional analysis for deriving a route for the hyperloop based on lateral acceleration limits. This time I looked at the other dimension of the problem: Elevation. This will complete the input data needed to fully simulate the Hyperloop.... 続きを読む >>

Configuring Models for Linear Analysis 1

One of the benefits of Model-Based Design is the ability to perform linear analysis on your non-linear model and design controllers using classical controls techniques. In R2013a, configuring your... 続きを読む >>

Comparing Runs using Simulation Data Inspector 13

Do you use the Simulation Data Inspector? Here is an example where it saved me a lot of debugging time. Simulation Accuracy I recently had to validate system behavior and analyze numerical... 続きを読む >>

Automatically Improving Model Performance

Since I joined the technical support department at MathWorks, one of the questions I received the most often is: Can you make my model go faster? Over the years I gained experience with model... 続きを読む >>

An Ounce of Design Min/Max is Worth…

Often, it is worth putting a bit of extra effort at the beginning of a project to save time later. Today I want to introduce a feature that gets more useful with every release of Simulink, but... 続きを読む >>

Posts 11 - 20 of 26